Online-Training - SIMATIC PCS 7 Process Safety (ST-PCS7SAF)

In this online training you will learn how to generate a PCS 7 conform and failsafe application with CFC and Safety Matrix.

Also available as face-to-face training

The theoretical parts of the training are backed up with practical exercises. These exercises are done with failsafe CPU 410-5H with failsafe signal modules connected via PROFIBUS and PROFIsafe. After the course you will be able to engineer safety functions and adjust safety relevant times.

Functional safety Basics from IEC 61508 and IEC 61511,
LOPA (Layer of Protection Analysis) and Risk graph by means of a safety instrumented function
System architecture and diagnostics in safety components (Hardware, Software, Communication)
Overview about F-Hardware
Parameter in HW-Configuration (safety mode, sensor evaluation, addressing, monitoring time, H-parameter, Wiring and Voting)
Safety program (Acknowledgement, voting blocks, block types, Secure Write Command++, communication)
Safety mechanisms (F-Shutdown, Partial Shutdown Groups, passivation, reintegration, block type)
Safety Matrix
Calculate and adjust F-times using S7ftime.xlsm (reaction-, monitoring times)

Attendance of training course ST-PCS7SYS. General basic knowledge of process automation. Basic knowledge of PCS 7 OS. Good experience in AS configuration within SIMATIC PCS 7.
In order to be able to take part in this course, you must install the Real VNC Viewer on your PC and the firewall used must not block the communication.
- Technical requirements > RealVNC