Mein Dashboard

Nutzen Sie unser Support Formular für eine zeitnahe Bearbeitung Ihres Anliegens.

SITRAIN Kundenberatung
Tel.: +49 (0)911-895-7575
E-Mail:

Leitfaden für die Registrierung (PDF download)


Um die Ansprechpartner für die Kursbuchung in Ihrer Region zu finden, klicken Sie bitte hier.

SINUMERIK ONE - Start-up and Service (NC-ONE-SIP)

  • This course provides knowledge for project planning and commissioning of the SINUMERIK ONE as digital twin and real, as well as the knowledge to create and test different machine configurations.

Ziele

  • This course provides knowledge for project planning and commissioning of the SINUMERIK ONE as digital twin and real, as well as the knowledge to create and test different mashine configurations.
  • In practical exercises, you train commissioning and service on training equipment.
  • After the course ends, you will master the commissioning of the SINUMERIK ONE control system with a SINAMICS S120 drive. By knowing the various functions of the controller, you are able to optimally adapt the control to the machine and thus maximize the productivity of your machine.
  • NC-NCAN course participants are advised to attend this course only after a period of gaining practical experience of 2 to 4 months.
Typ Präsenztraining
Dauer 10 Tage
Sprache en

Zielgruppe

  • Commissioning engineers
  • Engineering personnel
  • Service personnel

Inhalte

  • Overview and components of SINUMERIK ONE
  • Overview of SINUMERIK ONE functionality
  • Data backup of the SSD/SD as well as the IPC, recommissioning, SW upgrade
  • Commissioning of the digital twin with TIA portal and CreateMyVirtualMachine
  • Adaptation of the control functions to the machine with machine data and interface signals
  • Machine kinematics and collision monitoring
  • Transfer of data to the real machine
  • Drive configuration and axls assignment
  • Basics of optimization
  • PLC basic program and interface signals
  • PLC user program and user alarms
  • Commissioning of compensations and axls couplings
  • Adaptation SINUMERIK Operate
  • Introduction of synchronous actions
  • Practical commissioning exercises on the PC (digital twin) as well as on a SINUMERIK training device

Teilnahmevoraussetzung

  • Basic knowledge according to the course NC-NCAN.
  • Knowledges in TIA Portal equivalent to the course Tia-Sysup.
  • Relevant education, knowledge and experience to enable him or her to analyze risks and to avoid hazards which electricity could create.

Hinweise

  • none

Downloads