My Dashboard

Siemens Sanayi ve Ticaret A.S.
RC-TR DF CS
Yakacik Caddesi No 111
34870 Istanbul, Turkey
Tel.: +90 216 444 0 747
Fax: +90 216 4593586
E-Mail:

Online-Training SIMATIC S7-400H Redundant System (ST-7H400H)

Objectives

  • In this live online course, This course builds skills for sustaining and maintaining a Siemens S7-400H Redundant System. The course begins with an introduction to redundant automation system concepts, purpose and typical system architectures. The course then builds skills in hardware components, SIMATIC redundant project management and, specific hardware tools application. A light review of system program elements and tools is included to support systems level troubleshooting. The class will use a functioning redundant demo project with minimal system programming.
  • Numerous practical exercises using a TIA demo project plant model will reinforce theoretical knowledge. The TIA plant model consists of an S7-400H Redundant automation system, ET200M distributed I/O, SIMATIC Touch Panel, and a Conveyor model. Upon completion of the course, you are able to configure
  • and commission S7-400H hardware, redundant system remote I/O, diagnose redundant hardware faults through Simatic software tools, carry out safe hardware-only fault diagnostics, and replace modules in a running system thus, reduce costly redundant system downtimes
Type Online-Training
Duration 2 days
Language tr

Target Group

  • Maintenance personnel, Service personnel, Operators

Content

  • Configure and parameterize S7-400H Redundant system Hardware utilizing S7 Software tools
  • Perform startup procedures for S7-400H Redundant system hardware and software
  • Perform Configuration-in-Run (CiR) Replacement of Hardware
  • Maintain components of an S7-400H Redundant System.
  • Assemble redundant system hardware, cabling, wiring and, perform testing procedures.
  • Establish redundant system communication with multiple technologies.
  • Use standard STEP7 tools and methods for testing and diagnosing hardware & software problems in a
  • running redundant system.
  • Address and wire ET200M remote I/O signal modules
  • Configure and parameterize PROFIBUS DP and Ylink components

Prerequisites

  • S7 System Tools and Troubleshooting 1

Fee

428 EUR
( price without 20% VAT )

Downloads

Contact