My Dashboard

Contact

For information on course logistics, enrolment, timetables, payment and delivery methods, please contact us at

+39 02 8148 0441 from 09:00 to 17:30

MAIL:

For exclusive courses and meeting planning, please contact

MAIL: (Digital Industry Academy Training Manager)

On line-Training Migrazione da SIMATIC STEP 7 V5.x a TIA Portal con SIMATIC S7-1500 (TIA-SYSUP)

  • The Totally Integrated Automation Portal (TIA Portal) forms the work environment for integrated engineering with all automation devices: controller, operator panel and drives. In this course you will learn about the major differences between SIMATIC S7-300/400 and SIMATIC S7-1500, the engineering tools SIMATIC Manager and TIA Portal, as well as SIMATIC STEP 7 V5.x and SIMATIC STEP 7 (TIA Portal). You will learn the possibilities of the configuration and the advanced programming of a SIMATIC S7-1500 automation system with the TIA Portal engineering platform.

Objectives

  • After attending the course, you can:
    • Efficiently use the TIA Portal engineering platform
    • Configure and program components of the SIMATIC S7-1500 automation system with the TIA Portal
    • Perform a commissioning of TIA components
Type Online-Training
Duration 24 hours
Language it

Target Group

  • Programmers
  • Commissioning engineers
  • Engineering personnel
  • Service personnel

Content

  •  
    • Engineering tools TIA Portal components: SIMATIC STEP 7 and SIMATIC WinCC
    • Introduction of the SIMATIC S7-1500 hardware
    • Configuration of devices and networks of the SIMATIC S7 system family using SIMATIC S7-1500
    • Working with the PLC Tag Table in TIA Portal
    • Program blocks and program editor
    • Advanced programming possibilities of a SIMATIC S7-1500
    • Troubleshooting with TIA Portal tools and the SIMATIC S7-1500 CPU display
    • Presentation of the Structured Control Language (SCL) editor
    • Presentation of the SIMATIC WinCC operator control and monitoring system
    • Migration of a SIMATIC STEP 7 V5.x project to SIMATIC STEP 7 (TIA Portal)
    • Adaption of a SIMATIC S7-300/400 program to the SIMATIC S7-1500
    • Presentation of the SINAMICS Startdrive engineering tool with interfacing to a SINAMICS G120 drive
  • Theoretical knowledge will be deepened with numerous practical exercises on a TIA system model. This consists of a SIMATIC S7-1500 automation system, a SIMATIC ET 200 distributed I/O, a SIMATIC WinCC Advanced operator control, drive SINAMICS G120 and a conveyor model.

Prerequisites

  • Good theoretical and practical knowledge of SIMATIC S7 automation systems.

Note

  • This course is also available in Virtual Classroom mode: E-TIASYSUP.
  • At the end of the course you can deepen the topics covered through our SIE-learning 4.0: SIE-MIG, SIE-VARNT, SIE-PSIMAD, SIE-OPCUA.
  • In this course, the SIMATIC S7-1500 automation system and the SIMATIC STEP 7 (TIA Portal) software are used; MICRO1 and MICRO2 courses are available for the SIMATIC S7-1200 automation system.

Downloads

Contact