SINUMERIK 840D sl Safety Integrated Configuring and Start-up (NC-84SLSIW)
- Dates and Registration
- During this course, you will learn about configuring and commissioning the function Safety Integrated using the SINUMERIK 840D sl. Practical exercises with our test units concerning configuring, commissioning and servicing will be a major part of this training course.
- At the end of the course you will be extremely familiar with the function Safety Integrated using the SINUMERIK 840D sl, and be able to configure, test and commission specific installation configurations with safety functions - and all this all by yourself.
- This enables you to make full use of the adavantages of Safety Integrated on your machine tool.
- Commissioning engineers
- Engineering personnel
- Service personnel
- General information on safety technology; new standards
- System requirements
- Description of the safe basic functions
- Procedure during startup and troubleshooting
- Description of the machine data and interface signals
- Safe Programmeable Logics
- Safe Communications with PROFIsafe
- Evaluation of diagnosis and alarm displays
- Test stop
- Sensor / actuator integration with switching examples
- Safe brake management
- Acceptance test with Sinucom NC
- Safe Communication between several NCUs
- Safety Evaluation Tool SET
- Practical excercises on Training devices
- Basic knowledge according to the course NC-84SL-SIP