My Dashboard


My Profile

Please use our Support Form for your request.

SITRAIN Customer Information
Tel.: +49 (0)911-895-7575
E-Mail:

Registration Guideline (PDF download)


To find your regional training contact for booking, please click here.

Online Training - SINAMICS GM150 - Diagnostics and Service (DR-GM15-DG)

Short Description

  • In this online course you will learn how the SINAMICS GM150 converter works. After the course you can carry out troubleshooting and recommissioning. For this purpose, you will also be able to back up data using the STARTER PC program.

Objectives

  • You are responsible for service work and maintenance of medium-voltage converters.
  • In this course you will learn how the SINAMICS GM150 converter works in the circuit technology of the voltage source inverters VSI.
  • After the course you will be able to read and understand operating parameters. In the event of a fault, you can carry out a target-oriented troubleshooting and recommissioning. For this purpose, you will also be able to back up data using the STARTER PC program.
Type Online-Training
Duration 5 days
Language en

Target Group

  • Service personnel
  • Maintenance personnel

Content

  • Design and function of the SINAMICS GM150:
    • Principle of an inverter with DC-link voltage
    • Rectifier, precharge and circuit breaker
    • Inverter in IGBT and IGCT design
  • Operation and diagnostics with Operator Panel AOP30
  • Operation and diagnostics with PC program STARTER
  • Data backup:
    • Upload and download of parameter sets
    • Comparison of parameter sets
  • Reading and understanding circuit diagrams:
    • Input and output signals, setpoint channel
    • Control with CU320-2 and actual value measurements
    • Interface to PROFIBUS / PROFINET
  • Diagnostics and troubleshooting:
    • Checking the control and status signals
    • Analysis of alarm and error messages
    • Signal recording via trace function
  • Test functions after replacement of spare parts
  • Work safety on medium-voltage installations
  • Practical exercises on special remote training equipment

Prerequisites

  •  
    • Knowledge of electrical drive technology
    • Knowledge of SINAMICS or STARTER is not required
    • Technical requirements

Note

  • During the course you will work on special training equipment and partly on original equipment, adapted to low voltage (400 V) for your safety.
  • An introduction to the complete system and its operation under medium voltage (> 1000 V) is not covered by the course. This is usually done on site by personnel with the appropriate experience.

Downloads

Participant feedback

We ask the participants in our training to evaluate it on a set of criteria. Their average feedback on the “overall satisfaction” we publish for your information.

full starfull starfull starfull starfull star (4.8 of 5 for 4 ratings)