My Dashboard


My Profile

Please use our Support Form for your request.

SITRAIN Customer Information
Tel.: +49 (0)911-895-7575
E-Mail:

Registration Guideline (PDF download)


To find your regional training contact for booking, please click here.

SINAMICS SH150 - Diagnostics and Service (DR-SH15-DG)

Objectives

  • You are responsible for service work and maintenance of medium-voltage converters.
  • In this course you will learn how the SINAMICS SH150 converter works in the circuit technology of modular multi cells M2C.
  • After the course you will be able to read and understand operating parameters. In the event of a fault, you can carry out a target-oriented troubleshooting and recommissioning. For this purpose, you will also be able to back up data using the STARTER PC program.
Type Face-to-face training
Duration 5 days
Language en

Target Group

  • Service personnel
  • Maintenance personnel

Content

  • Design and function of the SINAMICS SH150:
    • Principle of the inverter in different circuits
    • Rectifier, inverter, DC-link and precharging
    • Inverter in modular multi cell design M2C
  • Operation and diagnostics with Operator Panel TP900
  • Operation and diagnostics with PC program STARTER
  • Data backup:
    • Upload and download of parameter sets
    • Comparison of parameter sets
  • Reading and understanding circuit diagrams:
    • Input and output signals, setpoint channel
    • Control with CU320-2 and actual value measurements
    • Interface to PROFIBUS / PROFINET
  • Diagnostics and troubleshooting:
    • Checking the control and status signals
    • Analysis of alarm and error messages
    • Signal recording via trace function
  • Test functions after replacement of spare parts
  • Work safety on medium-voltage installations
  • Practical exercises on special training equipment

Prerequisites

  • Knowledge of electrical drive technology
  • Knowledge of SINAMICS or STARTER is not required
  • The participant must be an electrically skilled person

Note

  • During the course you will work on special training equipment and partly on original equipment, adapted to low voltage (400 V) for your safety.
  • An introduction to the complete system and its operation under medium voltage (> 1000 V) is not covered by the course. This is usually done on site by personnel with the appropriate experience.
  • For customer-specific courses, please let us know the application in advance, such as 4-quadrant drive, grid feed, grid coupling or grid compensation.

Downloads