|

SINUMERIK PAL-Seminar C - Measurement and parameters (Online) (NC-PAL-C)

Our PAL seminars teach the use of PAL CNC examination controls with a 3D machine room and machining simulation. The CNC training in DIN/ISO code is comprehensively covered.
Currently, three seminars are being offered, which build on each other at least partially. The seminars introduce the application of the software components of the training software TopCNC-Suite.
Overview to this seminar:
- In-process measurement
- Parameter programming

Structure and Operation of 3D Probes
Quality control with 3D probes in the CNC machine, including rework with in-process measurements (with manual evaluation/with automatic evaluation)
Setting the zero point using 3D probes (G8 LM500 – G8 LM573)
Measuring geometric elements with all basic measurement cycles (G8 LM400 – G8 LM411)
Measuring geometric elements with machining cycles and the "Measure" machining selection (QM5)
Quality control with 3D probes in the CNC simulation, including good parts, rejects, rework with in-process measurements (determination of wear correction values)
Programming with sister tools
Programming modal tolerance values for form and positional deviations
Output of a measurement protocol
Parameter programming (system parameters, calculation parameters, parameter assignments, calculations with parameters, development of parameterized NC programs)
Methodology/Didactics: Design variants for CNC training and further education with the e-learning module TopTrain

Available as in-person seminar (in german language only), online seminar and on request as on-site training.