In this course you learn to determine the cause of faults and resolve them. You can also perform changes of the parameterization.
You will learn how to eliminate faults on the SINAMICS S210 drive system and determine their causes.
You will be able to perform diagnostics and component replacement in the event of a fault.
You will also be able to make changes to the parameterization.
You are responsible for reliable operation of the SINAMICS S210 drive system. If faults occur, then these should be resolved in the shortest possible time and operation resumed.
In this course, you will learn how to correctly and safely handle SINAMICS S210 drives when a fault occurs. Based on various scenarios, you will practice suitable measures such as data backup, replacing components and recommissioning.
After the course, you can determine the cause of faults and resolve them faster. When changes are made to the plant or system, you are also in a position to adapt the parameterization.
Design and principle of operation of the SINAMICS S210 converter system:
Power section and control
Motor, encoder and One Cable Connection
Data backup and diagnostics using:
Software Startdrive in the TIA PORTAL
Handling of the memory card
Internal interconnections to PROFINET
Procedure when troubleshooting and recommissioning
Checking the operating state and enable signals
Analysis of alarms and fault messages
Read-out of the diagnostics memory
Tracing signals using the trace function
Test operation using the control panel
Procedure when replacing:
Converter with control, motor and encoder
Components with safety functions Safety Integrated
Practical exercises on equipment with SINAMICS S210 operating at 1AC/230V
Basic knowledge of drive technology
Basic knowledge of the SIMATIC TIA Portal (according one of the courses TIA-SERV1, TIA-PRO1 or TIA-SYSUP)