手动工程和机械材料处理学习单元
Machine familiarization
- Complete machine
- Control panel
- Cross slide-Ball screw drive，Y axis
- Cross slide-Guide，Y axis
- Cross slide-Servo motor，Y axis
- Machine column-Ball screw drive，Y axis
- Machine column-Guide，Y axis
- Machine column-Servo motor，Y axis
- Cross slide-Ball screw drive，Y axis
- Cross slide-Guide，Y axis
- Cross slide-Servo motor，Y axis
- Spindle head-Main drive motor
- Spindle head-Clamping cylinder
- Spindle head-Centre sleeve
- Clamping table-Vice
- Clamping table-Clamping claws
- Clamping table-Workpiece
- Clamping table-orkpiece zero point
- Clamping table-Machine zero point
- Tool magazine-T1 Face-milling cutter 63mm
- Tool magazine-T2 Slot milling tool 20mm
- Tool magazine-T3 Slot milling tool 10mm
- Tool magazine-T4 Spiral drilling tool 8.5mm
- Tool magazine-T5 Thread drilling tool M10
- Tool magazine-T6 Remote measuring probe
- Switch cabinet-Supply module
- Switch cabinet-Supply module
- Switch cabinet-PLC
- Components-Cabin
- Components-Main switch
- Components-RH maintenance flap
- Components-LH maintenance flap
- Components-Coolant lubricant basin
- Components-Sliding lubricant basin
- Components-RH chip basin
- Components-LH chip basin
- Components-Status light
Machine Set-up
- Sinumerik 840D -Milling
- Setting up the machine-Switching on
- Setting up the machine-Manual movement
- Setting up the machine-Tool compensations
- Setting up the machine-Workpiece zero point
Fundamentals
- Programming-Write a program
- Programming-Edit a program
- Programming-Operate a program
- Fundamentals
- Milling fundamentals
- Geometry-Coordinate systems
- Geometry-Points on workpiece
- Geometry-Absolute dimensions
- Geometry-Incremental dimensions
- Geometry-Polar dimensions
- Geometry-Contour setting
- Technology-Speed
- Technology-Cutting speed
- Technology-Feed rate
- Technology-Feed /tooth
- Program configuration
- Program header
- Addresses F,S,T,D,M
Travel commands G0,G1,G2,G3
Tool path compensations
Tool offsets
Cycles/subroutines
