My Dashboard

Contact

For all your questions for product learning you can contact our Customer Care Centre

Tel +32 2 536 2700

MAIL :

Online training: SIMATIC TIA Portal - S7-1500 system retraining cursus (TIA-SYSUP)

  • The Totally Integrated Automation Portal (TIA Portal) forms the work environment for integrated engineering with all automation devices – controller, HMI and drives. In this course you will learn about the major differences between SIMATIC S7-300/400 and SIMATIC S7-1500, the engineering tools SIMATIC Manager and TIA Portal, as well as STEP 7 V5.x and STEP 7 based on TIA Portal. You will learn thepossibilities of the configuration and the advanced programming of a SIMATIC S7-1500 automation system with the "TIA Portal" engineering platform.

Objectives

  • After attending the course, you can:
    • Efficiently use the "TIA Portal" engineering platform
    • Configure and program components of the SIMATIC S7-1500 automation system with the TIA Portal
    • Perform a commissioning of TIA components
  • You can deepen your theoretical knowledge with numerous practical exercises on a TIA system model. This consists of a SIMATIC S7-1500 automation system, ET200 distributed I/O, Touchpanel, drive, and a conveyor model.
Type Online-Training
Duration 5 days
Language de, en, fr, nl

Target Group

  • Programmers
  • Commissioning engineers
  • Engineering personnel
  • Service personnel

Content

  • Engineering tools TIA Portal components: SIMATIC STEP 7 and SIMATIC WinCC
  • Introduction of the SIMATIC S7-1500 hardware
  • Configuration of devices and networks of the SIMATIC S7 system family using SIMATIC S7-1500 as an example
  • Working with the PLC Tag Table in TIA Portal
  • Program blocks and editor
  • Advanced programming possibilities of a SIMATIC S7-1500
  • Troubleshooting with TIA Portal tools and the SIMATIC S7-1500 CPU display
  • Presentation of the Structured Control Language (SCL) editor
  • Presentation of the SIMATIC WinCC operator control and monitoring system
  • Migration of a SIMATIC STEP 7 V 5.x project to SIMATIC STEP 7 based on TIA Portal
  • Adaption of a SIMATIC S7-300/400 program to the SIMATIC S7-1500
  • Presentation of the 'Startdrive' engineering tool with interfacing to a SINAMICS G120 drive
  • Deeper understanding of contents through practical exercises on the SIMATIC S7-1500 system model

Prerequisites

  • SIMATIC S7 knowledge according to ST-S7SYS2 and practical experience in using the knowledge
  • You can use the available online entry test to ensure that the selected course matches your area of expertise.

Note

  • In this course you will work with SIMATIC S7-1500 and software SIMATIC STEP 7 based on TIA Portal.

Downloads

Contact